Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use MERV 13 or HEPA filter sheet cut to the wall size, and a 5 V USB fan. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Use calcium chloride refill crystals. Keep away from children and pets. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; wipe with alcohol first. Use oyster mushroom grain spawn mixed with pasteurised hemp hurds or sawdust. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in clear PETG so you can see the passenger. Use a postcard or playing card as the gate. Prints as shown on its floor, no supports.
PETG. Use 1-2 cm of water and change it every two days; keep it on a bright windowsill. Prints as shown on its floor, no supports.
PETG for a watertight tray; top it up every day or two. Prints as shown on its floor, no supports.
Set the inner size to your jar plus 2 mm. Prints as shown on its floor, no supports.
Set the diameter to the bucket base plus 4 mm. Prints as shown on its floor, no supports.
Print upright; stand it in a tray of damp perlite. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.