Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Regrow lettuce, celery, spring onions and carrot tops from kitchen scraps
The root ends you throw away will grow again. Stand a lettuce or bok choy stump in the wide dish, a celery base in the shallow one, the white roots of spring onions upright in the tall tube and carrot tops in the small cup, each in a little water. Within days new leaves push up from the middle: spring onions can be cut again in a week, celery grows a new heart and carrot tops sprout feathery greens for pesto. Each well is labelled in its floor.
Printing notes
110.4 cm³
Volume
136.9 g
Est. weight
13,256
Triangles
PETG. Use 1-2 cm of water and change it every two days; keep it on a bright windowsill. Prints as shown on its floor, no supports.
MAIN PURPOSE: Collect kitchen scraps for composting
A kitchen scrap bin with a swing lid: push the flap to drop peelings in and it falls shut.
Printing notes
240.2 cm³
Volume
297.9 g
Est. weight
6,012
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
MAIN PURPOSE: Sort cans and plastics for recycling
A two-compartment recycling bin with an open dome top: cans one side, plastics the other.
Printing notes
417.1 cm³
Volume
517.2 g
Est. weight
336
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
MAIN PURPOSE: Collect wine corks for reuse
A tall square jar with a honeycomb pattern all round and a lift-off lid for collecting corks.
Printing notes
215.4 cm³
Volume
267.1 g
Est. weight
38,764
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.