Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG; wipe with alcohol first. Use oyster mushroom grain spawn mixed with pasteurised hemp hurds or sawdust. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in clear PETG so you can see the passenger. Use a postcard or playing card as the gate. Prints as shown on its floor, no supports.
PETG for a watertight tray; top it up every day or two. Prints as shown on its floor, no supports.
Set the inner size to your jar plus 2 mm. Prints as shown on its floor, no supports.
Set the diameter to the bucket base plus 4 mm. Prints as shown on its floor, no supports.
Print upright; stand it in a tray of damp perlite. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print a few; PETG keeps the tines straight. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
PETG with solid walls so it stays watertight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.