Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print abacus down; flip to use. Set the socket to your tube. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Felt pads under the plinth protect floors. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the show face down for a glassy finish; silk PLA reads as metal. Prints flat as a plate, no supports.
Print four or eight; M6 rod, nuts and washers. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print four in PETG; 10 mm rope. Prints as shown on its floor, no supports.
PETG for bathrooms. Prints as shown on its floor, no supports.
Print the lid face down for a smooth picture surface. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Use screws 3 mm longer than the originals. Prints as shown on its floor, no supports.
Print on its end in PETG; jaw fits a 20 mm deep architrave. Prints as shown on its outline, no supports.
Print many in one colour or a gradient; 15 mm split rings. Prints flat as a plate, no supports.