Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
ASA or PETG; lay it with the hood facing away from the weather and run the cords through the side ports. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Match cloth colours to the coloured words: blue glass, red bathroom, green kitchen, yellow dusting. Prints as shown on its floor, no supports.
The long side slot takes a pencil and a mini spirit level. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Load a stack of flat shoe covers through the top; screw to the wall at shoe height. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print upright in PLA; two screws through the keyholes. Prints as shown on its floor, no supports.
PLA or PETG, printed upright. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print the cup in TPU, or line it with rubber. Print floor-down as shown, then turn it over to use it.
Print on its back in PLA or PETG; two M4 bolts and nuts. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG so it shrugs off hot water. Prints as shown on its floor, no supports.
Print in PLA; fill with dry sand and tape the lid shut. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.