Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print as it comes; rootlets print solid.
Print in white or pearl PETG. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits a 6 x 4 inch landscape photo. LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print standing as shown; the 4 mm wall is solid. Prints as shown on its outline, no supports.
Print face down; back the photos with card and tape. Prints as shown on its floor, no supports.
Print upright; grip feet stop it sliding. Prints as shown on its floor, no supports.
Print flat; slots are 3.5 mm for 3 mm walls.
Print flat; print four to six in contrasting filaments.
Print flat in a light colour.