Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print lying on its side, or as it comes. Prints as shown on its floor, no supports.
Print in PETG and rinse well before it goes in the tank. Print floor-down as shown, then turn it over to use it. Large holes in the walls may need supports or good bridging.
Print with 100% infill and check against calipers. Prints as shown on its outline, no supports.
Print in translucent yellow or blue. Prints flat as a plate, no supports.
For food contact, print in a food-safe PETG and wash by hand. Prints flat as a plate, no supports.
Print flat in PETG.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in PETG or ASA, which stays tough in the cold. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print a set. Prints flat as a plate, no supports.
Print in TPU for a soft grip. Prints as shown on its floor, no supports.