Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Matt black PLA; tape the lid seam against light leaks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; drop in a stainless nut so it sinks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; use 80 grit sandpaper. Prints as shown on its floor, no supports. The added base's lid prints separately.
Food-safe PETG. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print four; glue felt underneath. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in PETG; plug metal shells need to be 7 mm long. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in a dark colour. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Add 2 mm wire, a buzzer, a 5 mm LED and 2 AA cells. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The added bases' lids print separately.