Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Write the grain weights on the lid label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food contact: line the bays or use food-safe PETG and wash by hand. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG; the lid keeps leftovers in the fridge in the same tray. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Mount on a post or fence through the keyholes; ASA or PETG outdoors. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Put it between two seats; a half turn swaps the sides. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Fits batons up to 290 mm with a 22 mm handle; print lying flat. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG; keep it away from the window. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Keep a separate scoop in each bay; one stray coarse grain scratches a whole polish batch. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Load a stack of flat shoe covers through the top; screw to the wall at shoe height. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Drop in three nursery pots up to 9 cm; give it a third of a turn every morning. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.