Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Needles go in the screw-top tube so they never end up in a toe pad. Prints as shown on its floor, no supports. The added base's lid prints separately.
Write the model and part numbers on the label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Thread a belt or the lead's waist strap through the back slots. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print the cover, turn it over the cheese; the flat lid is the board underneath. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
The small screw-top keeps the needles; the tube takes pumps up to 32 mm. Prints as shown on its floor, no supports. The added base's lid prints separately.
The lid keeps the sand soft between sessions; the side garage holds moulds and tools. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Drop toy bones in, pour plaster with a little sand, leave 24 hours, then lift the block out by the lid and dig with a brush. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The long side slot takes a pencil and a mini spirit level. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Rows fit floats up to 280 mm; wrap the delicate tips in foam if you like. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the turntable ring separately and drop in 6 mm steel or airsoft balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.