Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG. Print upright; a 16 mm cane. Prints as shown on its floor, no supports.
Print upright in a dark colour so the layers stand out. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print upright in limestone grey. Prints as shown on its floor, no supports.
Print it as shown, then turn it over so the floor becomes the top. PETG. Print floor-down as shown, then turn it over to use it.
Print upright; PVA or hot glue for the finds. Prints as shown on its floor, no supports.
Print upright. Prints as shown on its floor, no supports.
Food-safe PETG. Prints as shown on its outline, no supports.
Arches print bridged; no supports at 0.2 mm layers. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print upright; ledges self-support at 45 degrees. Prints as shown on its floor, no supports.
Arches bridge cleanly; print walls at 3 mm. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.