Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The cups take standard tape rolls; the box takes stick wax and a lace hook. Prints as shown on its floor, no supports.
The round pot holds styptic powder in case a nail bleeds. Prints as shown on its floor, no supports.
Screw to the wall through the two keyholes; PETG for a garage. Prints as shown on its floor, no supports.
Print in white or a pale colour so the paper colours stand out. Prints as shown on its floor, no supports.
The cup takes handles up to 58 mm; feed the charger cable through the back slot. Prints as shown on its floor, no supports.
Slots take acrylic rulers up to 16 mm thick; weight the base with a few coins if your rulers are tall. Prints as shown on its floor, no supports.
Push stud posts through the pod holes; the backs sit safely in the chamber underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Holes take pens and markers up to 12 mm. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the cloud white and the cups blue. Prints as shown on its outline, no supports.
Keep 1-2 cm of rain or distilled water in the outer tray at all times; never tap water. Prints as shown on its floor, no supports. Stacked parts are fused into one print.