Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG. Print upright; a 16 mm cane. Prints as shown on its floor, no supports.
Print upright in a dark colour so the layers stand out. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print upright in sandstone PLA. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print upright in dark grey. Prints as shown on its floor, no supports.
PETG, 4 perimeters for watertight walls. Prints as shown on its floor, no supports.
Print it as shown, then turn it over so the floor becomes the top. PETG. Print floor-down as shown, then turn it over to use it.
Print as it comes; rootlets print solid.
Print body and lid flat. Optional 10 mm magnet glued under the floor. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in white or pearl PETG. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Print body and lid flat. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.