Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flat in PETG, 2 mm; print six to ten.
Print as it comes (comb on the bed), solid; fix with foam tape.
Print several; 3 mm cord and a bead to clamp. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat; the peg prints upright, a touch of support under the cap. Stacked parts are fused into one print.
Print floor down. Prints as shown on its floor, no supports.
Print eight flat in PETG; twelve M4 bolts and nylock nuts. Prints flat as a plate, no supports.