Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as it comes (profile on the bed); the ribbon is solid.
Print flat; print 100 %, 75 % and 55 % widths for three tiers.
Uses the lazy-Susan ball bearing base. Matt deck colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.
Print in two colours with a filament swap at 30 mm. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the drawer in a contrasting colour. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Print flat in PETG for a smooth slide.
Two 4 mm rods 260 mm long; twenty 20 mm wooden beads. Prints as shown on its floor, no supports.
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.