Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Hang through the keyholes; each ledge takes about six thimbles. Prints as shown on its floor, no supports.
Print the heart vessel in white; fill the two cups with contrasting sand. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Uses the editor lazy-Susan base with BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports.
Print several; 0.3 mm joint clearance built in. Prints as shown on its outline, no supports.
Print four; they work in any corner by turning. Prints as shown on its floor, no supports.
Print on its side (profile on the bed) in PETG.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Prints flat as a plate, no supports.