Swap Corners

Display and swap records, prints and paintings

Corner keepers for framing without a frame. Screw four to the wall on their tabs and slide an LP sleeve, art print on board or a child painting under the lips of the two top and two bottom corners: it is held flat by the corners only, and swaps in seconds.

Customize this model

Size (Base A): 50 × 50 × 10 mm
Shape: Square
Walls: 3.0 mm
Volume: 9.3 cm³
Est. weight (PLA): 11.6 g
Parts to print: 1
Category: Collections & display
Made by: Krypto
Built in: 24 steps

What’s in it

Square, 50 × 50 × 10 mm, with 3.0 mm walls
1 hole in the floor
One more base built on (Base B)
Base B: rectangular, 50 × 16 mm, 3 mm tall (beside)

How to print it

Print four; they work in any corner by turning.

Prints as shown on its floor, no supports.

Filament: at most about 11.6 g of PLA printed solid (roughly $0.23 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the swap Corners model?

The swap Corners model measures 50 × 50 × 10 mm (width × depth × height). That is Base A; one more base is built on. You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

No. Print four; they work in any corner by turning. Prints as shown on its floor, no supports.

How much filament does it use?

At most about 11.6 g of PLA (9.3 cm³ printed solid), roughly $0.23 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.