Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG or PP. Fill only the outer ring with water, freeze overnight, then dip in warm water and the ice slides out. Prints as shown on its floor, no supports.
PETG. Fill with water to 1 cm below the rim; push the magnetised needle through a thin slice of cork. Prints as shown on its floor, no supports.
Trace one side per four slow counts: in, hold, out, hold. Four laps is about a minute. Prints as shown on its floor, no supports.
Drop a 12 cm nursery pot inside; the ribs keep its sides cooler in full sun. Prints as shown on its floor, no supports.
Use four coins each; slide from the notched end, score where they stop, and knock opponents off. Prints as shown on its floor, no supports.
Cut corrugated cardboard into 40 mm strips and stand them on edge, packed tight; flip them when worn. Prints as shown on its floor, no supports.
Print in a dark filament so it warms in the sun; stretch cling film over the rim, hold it with a rubber band and set a pebble right above the centre cup. Prints as shown on its floor, no supports.
Write each name on a lolly stick, stand them in PICK; once a name is picked it moves to DONE until everyone has had a turn. Prints as shown on its floor, no supports.
Write the due date on a card in the label slot; every library book lives here when it isn't being read. Prints as shown on its floor, no supports.
Lay coated paper on the floor, leaves on top, then a 2 mm glass sheet on the ledges; expose 10-15 minutes in sun. Prints as shown on its floor, no supports.