Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Print in PETG. Prints flat as a plate, no supports.
Print two. Prints as shown on its outline, no supports.
Add two 140 x 104 mm acrylic sheets. Prints as shown on its floor, no supports.
Add an LED strip and a 154 x 104 x 3 mm opal acrylic sheet. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Large print: about 240 mm square. Print in white for the brightest light. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print floor-down (the floor is the hood's roof), no supports. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.