Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Matt black PLA; tape the lid seam against light leaks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; drop in a stainless nut so it sinks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; use 80 grit sandpaper. Prints as shown on its floor, no supports. The added base's lid prints separately.
Print in a dark colour. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Add 2 mm wire, a buzzer, a 5 mm LED and 2 AA cells. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The added bases' lids print separately.
Print six; glue the lids once filled. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in black. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.