Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print many in one colour or a gradient; 15 mm split rings. Prints flat as a plate, no supports.
Print flat in PLA; press or glue an M8 nut into each pad.
Print upright; drop a bag of sand into the base for weight. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print flat; print 100 %, 75 % and 55 % widths for three tiers.
Two 4 mm rods 260 mm long; twenty 20 mm wooden beads. Prints as shown on its floor, no supports.
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print 24 flat in PETG; 36 M3 screws and nylock nuts. Prints flat as a plate, no supports.
Print twelve flat; two M3 bolts. LED lights only. Prints flat as a plate, no supports.
Print four flat in PETG; M4 bolts, nylock nuts, a pencil. Prints flat as a plate, no supports.