Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the three pods separately. The pegs under each pod sit in the pod below; laid flat they act as feet. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Use a multi-port USB charger, leave slack in its lead so the drawer opens fully, and don't shut away a charger that runs hot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Glue the neck plate onto the shelf inside the rim, then the cap screws on. Change the cap lettering for each brick. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print the number of bins the badge shows. Because they are identical, any bin fits any spot. Prints as shown on its floor, no supports.
Needs a drawer at least 75 mm deep inside. Print the deck separately. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pockets are sized for typical tools; change each bay's pocket size to fit yours. Prints as shown on its floor, no supports.
For drawers at least 160 mm deep inside. Prints as shown on its floor, no supports.
Fits jars up to 45 mm across and 105 mm long; ten jars per insert. Prints as shown on its floor, no supports.
The base ring prints separately. Needs 55 mm of drawer depth. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print a set at 100, 88 and 76 % so they nest one inside the next. Prints as shown on its floor, no supports.