Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Food-safe PETG. Blend 1 g sodium alginate into 200 ml juice and dissolve 2.5 g calcium chloride in 500 ml water. Prints as shown on its floor, no supports.
Food-safe PETG. Print it as one piece; the walls where the circles cross make all seven bays. Prints as shown on its floor, no supports.
Print the body and slotted top in clear PETG so the piles show. Swap the labels with paper stickers week by week. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG. Use 1-2 cm of water and change it every two days; keep it on a bright windowsill. Prints as shown on its floor, no supports.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.