Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece; the pens rest on the desk inside. Print floor-down as shown, then turn it over to use it.
Print upright in limestone grey. Prints as shown on its floor, no supports.
Arches print bridged; no supports at 0.2 mm layers. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print upright; ledges self-support at 45 degrees. Prints as shown on its floor, no supports.
Print several in brick red, concrete grey or white. Prints as shown on its floor, no supports.
Print flat at 0.2 mm layers; PETG flexes without snapping.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print at 100 % infill so the bob has weight. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Print four. Prints as shown on its floor, no supports. Stacked parts are fused into one print.