Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in PETG or nylon. Prints flat as a plate, no supports.
Print flat in PETG; print a set.
Print in PETG for a bit of flex. Prints flat as a plate, no supports.
Print in PETG. Prints flat as a plate, no supports.
Print in ASA or PETG for outdoors. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print four in TPU or PETG. Print floor-down as shown, then turn it over to use it.
Print floor-down as shown, then turn it over to use it.
The 22 mm bore is a press fit; sand it lightly if the bearing will not go in. Prints flat as a plate, no supports. Large holes in the walls may need supports or good bridging.