Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Runners: two Clasp Rails with a 55 mm wall. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat; the peg prints upright, a touch of support under the cap. Stacked parts are fused into one print.
Print floor down. Prints as shown on its floor, no supports.
Print eight flat in PETG; twelve M4 bolts and nylock nuts. Prints flat as a plate, no supports.
Print as shown (profile on the bed), 100 % infill on the arm. Prints as shown on its outline, no supports.
Print face down; paint with the wall. Two screws or mounting tape. Prints as shown on its floor, no supports.
Print face down; print six or nine for a screen. Prints as shown on its floor, no supports.
Print as it comes in PETG or TPU.
Only for sheathed flex, never bare wires. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.