Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Drop in three nursery pots up to 9 cm; give it a third of a turn every morning. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Wire coils sit on their sides in the round cups so they don't tangle. Prints as shown on its floor, no supports.
Fits 2-inch net cups; float or rest it on a dark tub and top up only once. Prints as shown on its floor, no supports.
Glue the lid down once baited; put it along the ant trail. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fill with natural, untreated wool, cotton or pet fur, never dryer lint or synthetic yarn. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG for the dish. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; print standing on its back plate. Plants up to about 3 kg. Prints as shown on its floor, no supports.
Green or wood-fill PLA; PETG near a bathroom. Prints flat as a plate, no supports.
PETG. Print flat.
PETG. Print upright; a 16 mm cane. Prints as shown on its floor, no supports.