Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in grey or stone-effect filament. Place it lid-down. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Cut the glass or acrylic about 195 x 115 mm. Stand it on a saucer. Prints as shown on its floor, no supports.
Tape over the holes until the bucket is white with mycelium, then uncover and mist daily. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use cotton or nylon cord. Stand the tank level with the pots or higher. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print the pedestal on its wide end, it needs no supports. Prints as shown on its floor, no supports.
Needs a 200 mm bed. Weight the pedestal with sand or gravel. Prints as shown on its floor, no supports.
The legs print separately, standing on their pads. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.