Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Print flat at 2 mm with fine layers so the notch edges stay crisp.
Prints flat as a plate, no supports.
Print in PETG or TPU so the clip flexes. Prints flat as a plate, no supports.
Print with low (10%) infill so the ring floats. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print lying flat so the layers run along the hook; PETG holds better than PLA.
Print as it comes (wedge outline on the bed); PETG or TPU grips floors best.