Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print two and play from opposite ends of the table. Prints as shown on its floor, no supports.
Stand it in a baking tray. Rinse after each eruption. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print it as shown, then turn it over: the floor becomes the roof. Lay a strip of white card on the ground inside with an ink pad (powdered charcoal in vegetable oil on a sponge) across the middle. Print floor-down as shown, then turn it over to use it.
Print two. Push 6 mm clear tubing into the ports and seal with silicone; a drop of food colouring makes the water easy to see. Prints as shown on its floor, no supports.
Stretch a cut balloon, shower cap or plastic bag drum-tight over the open top and tape it all round. Tap the middle sharply. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
PETG; wipe dye off straight away. Twist the damp shirt flat round a fork in the centre circle, band it into six wedges along the ribs. Prints as shown on its floor, no supports.
Stuff it with straw or wood wool, push a cane through the hole and hang it upside down in the tree, open end down. Prints as shown on its floor, no supports.