Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print the lid in clear or white so light comes through. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in white ASA or PETG for outdoor use. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
For food contact, print in a food-safe PETG and wash by hand. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.