Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Screw or tape it to the enclosure side; the slot takes scrapers up to 8 mm thick. Prints as shown on its floor, no supports.
Fill the race with 6 mm airsoft BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print a few in a bright colour. Prints flat as a plate, no supports.
Print several in PETG; check the 2 mm thickness against your coupler. Prints flat as a plate, no supports.
Print in PETG or ASA. Prints as shown on its floor, no supports.
Print in PETG or ASA; the iron barrel should not touch the bore for long. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the grips in PETG. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print in TPU. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in PETG and wear gloves; resin attacks PLA over time. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints flat as a plate, no supports.