Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in translucent yellow or blue. Prints flat as a plate, no supports.
Print flat in PETG.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in PETG or ASA, which stays tough in the cold. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Holes print a little small; open each one with the matching drill bit for a true reading. Prints flat as a plate, no supports.
Flip it so the pegs point down into the tray. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.