Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print on its side (profile on the bed) in PETG.
Print on its end in PETG; print enough lengths to span the shelf. Prints as shown on its outline, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Prints flat as a plate, no supports.
Print abacus down; flip to use. Set the socket to your tube. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Felt pads under the plinth protect floors. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the show face down for a glassy finish; silk PLA reads as metal. Prints flat as a plate, no supports.
Paint the facades before closing; battery LEDs only. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print four or eight; M6 rod, nuts and washers. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print four in PETG; 10 mm rope. Prints as shown on its floor, no supports.