Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in turquoise; sabzeh sprouts grow happily in the corner bay. Prints as shown on its floor, no supports.
Print the heart vessel in white; fill the two cups with contrasting sand. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Add a pinch of calcium powder, drop in the crickets, cap it and shake gently. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Run the seat's lap strap or a buckle strap through the side slots. Prints as shown on its floor, no supports.
Sort by colour family left to right; the scooped front wall makes the front row easy to pick from. Prints as shown on its floor, no supports.
PETG or ASA outdoors; the perforated floor drains splashes. Prints as shown on its floor, no supports.
Print upright in PLA; two screws through the keyholes. Prints as shown on its floor, no supports.
PLA or PETG, printed upright. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print the cup in TPU, or line it with rubber. Print floor-down as shown, then turn it over to use it.
Print on its back in PLA or PETG; two M4 bolts and nuts. Prints as shown on its floor, no supports. Stacked parts are fused into one print.