Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print four, one per seat; the five slots take the bid cards from 1 to 7. Prints as shown on its floor, no supports.
Light colour so the ball shows. Use an 8 mm steel ball. Prints as shown on its outline, no supports.
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print two flat in PETG, 4 mm, in two colours. Prints flat as a plate, no supports.
Print in black; fill with cork or putty. 6 x 2 mm magnet. Prints as shown on its outline, no supports.
Print open side up, glue in a coin, then flip. Print floor-down as shown, then turn it over to use it.
Print in black with gold text paint. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the plate on the bed, the post upright. Print floor-down as shown, then turn it over to use it.
Print six or more. Prints as shown on its floor, no supports.
Print one per track in each player colour; PETG springs best. Prints as shown on its outline, no supports.