Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Lean it back against a wall or a stack of books at about 60 degrees, open side up, and drop a 14-16 mm marble in at the top. Prints as shown on its floor, no supports.
Hide a sweet (the car) in one box and nothing (the goats) in the other two. Play 20 rounds sticking and 20 switching, and keep score. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added bases' lids print separately.
Print the tower in clear PETG so the beads show; use 8 mm beads. Shake the coins in the front tray; the back foot keeps it steady. Prints as shown on its floor, no supports.
Food-safe PETG. The numbers are engraved in the floors of the bays. Prints as shown on its floor, no supports.
Use four coins each; slide from the notched end, score where they stop, and knock opponents off. Prints as shown on its floor, no supports.
Stack the nine whites and nine blacks in the side bays; the queen and striker sit in the centre. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print the turntable ring separately and drop in 6 mm steel or airsoft balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the sleeve upright and the two drawers flat; line the cells with felt for wooden pieces. Prints as shown on its floor, no supports. The 2 drawers print separately from the case.
Sized for travel checkers up to 34 mm across; scale the tubes for full-size checkers. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added bases' lids print separately.
Print two, one for each player; a wood-fill filament suits the game. Prints as shown on its floor, no supports. Stacked parts are fused into one print.