Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Join two pen cups with a sliding dovetail
Two identical pen cups that slide together on a dovetail into one 80 mm square block, the way Japanese joinery locks timbers. Turn one cup round, lower it onto the other and the tail drops into the socket; lift one off to share it across the desk.
Printing notes
69.5 cm³
Volume
86.2 g
Est. weight
940
Triangles
Print two; same orientation, they mate when one is turned. Prints as shown on its outline, no supports.
MAIN PURPOSE: Keep small items covered inside a locking set
The lidded member of the Locktile system: a 70 mm hexagonal canister with a telescoping lid that keeps clips, tea bags or beads covered while its jigsaw edge still locks into cups and plates beside it.
Printing notes
118.1 cm³
Volume
146.4 g
Est. weight
8,924
Triangles
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Keep pens in a canyon between two cliff planters
A desk landscape with a river of pens. Two cliff planters, one low and one high, frame a narrow canyon floor where pens and pencils lie; fill the clifftops with moss, sand or small succulents. Seen from the side it is a tiny gorge running along the front of your monitor.
Printing notes
37.3 cm³
Volume
46.3 g
Est. weight
1,332
Triangles
Print in sandstone colours; the planters need no drainage for moss. Prints as shown on its floor, no supports.
MAIN PURPOSE: Sort pens, earbuds and clips on a rooftop scene
A city rooftop as a desk tidy. The parapet-walled deck catches clips and keys, the water tower is the pen cup and the stair bulkhead with its little door holds earbuds or sticky flags. A rooftop scene that does the work of three organisers.
Printing notes
90.0 cm³
Volume
111.6 g
Est. weight
6,144
Triangles
Print in concrete grey with a rust-red water tower. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.