Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Sea-glass green translucent PETG looks right. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.
Print in PETG. Prints flat as a plate, no supports.
Print two. Prints as shown on its outline, no supports.
Print in black. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Add two 140 x 104 mm acrylic sheets. Prints as shown on its floor, no supports.
Add an LED strip and a 154 x 104 x 3 mm opal acrylic sheet. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints as shown on its floor, no supports.