Models Showcase

Line the bed with a scrap of felt; write the rock's name on masking tape across the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Write the years on the dividers with a paint pen; the lid keeps the stubs from fading. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Tape a card square to the floor, give it a fast spin and drip runny paint from a squeeze bottle. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.

Stack the nine whites and nine blacks in the side bays; the queen and striker sit in the centre. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Add an unglazed tile, a glass slide, a steel nail, a copper coin, a magnet and a 10x loupe. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Hang it inside the tank rim; the slots let water flow but keep adult fish out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Keep doubles in GOT for swapping at school; the stickers you still need go in NEED, in album order. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

One number per bay; the last two bays take the small candles and a lighter. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Print in orange with the pumpkin in black. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Screw it to the coop wall at back height; fill the left side with grit, the right with crushed oyster shell. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.