Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print open side down; 8 mm and 6 mm dowels. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG. Print upright; a 16 mm cane. Prints as shown on its floor, no supports.
Print upright in a dark colour so the layers stand out. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print it as shown, then turn it over so the floor becomes the top. PETG. Print floor-down as shown, then turn it over to use it.
Print upright; PVA or hot glue for the finds. Prints as shown on its floor, no supports.
Print upright. Prints as shown on its floor, no supports.
Fits a 6 x 4 inch landscape photo. LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Needs a 25 to 35 mm hanging bell and a bamboo skewer. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Deck on the bed. Print it as shown, then turn it over so the floor becomes the top. Needs ball chain and a mirror tile. Print floor-down as shown, then turn it over to use it.
Print eight, same settings so they weigh the same. Prints as shown on its floor, no supports. Stacked parts are fused into one print.