Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Silk or dual-colour PLA makes the twist stand out. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the pleat depth or the twist in the editor to make your own.
Silk or dual-colour PLA makes the twist stand out; 3 walls keep the pleats solid. Prints as shown on its floor, no supports.
PETG. Fits a waterproof A6 notepad (or a slate of white plastic and a grease pencil). Screw it up through the keyholes. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Mount with keyholes on screws or stick-on hooks; the slotted floor drains. Prints as shown on its floor, no supports.
Magnets go in the right-hand bay away from the pins, so they don't clump together. Prints as shown on its floor, no supports.
Mount at adult height; wash the spacer as your nurse advises and let it dry in the tube. Prints as shown on its floor, no supports.
Write the perfume name at the bottom of each strip before you spray. Prints as shown on its floor, no supports.
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
PETG. Print flat.