Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as it comes (profile on the bed) in PETG.
Print flat in PETG.
Print as it comes (profile on the bed) in PETG, 30% infill.
Fix the clipper with a dab of putty adhesive. Prints as shown on its floor, no supports.
Fix with two small screws or a strip of foam tape. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as it comes (profile on the bed) in PETG.
Print diagonally or in two halves on a small bed. Prints as shown on its floor, no supports.
PETG 1.6 mm so it follows the body; wipe clean after use. Prints flat as a plate, no supports.
Fits bottles up to 24 mm across. Prints as shown on its floor, no supports. Stacked parts are fused into one print.