Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as many tiles as the window needs. Prints flat as a plate, no supports.
Add a 5 V USB LED strip about 15 cm long. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print two, profile on the bed, in PETG. Prints as shown on its outline, no supports.
PETG with 3 walls; keep 2 cm of water in the chamber. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Always bed the incense on sand; print in PETG. Prints as shown on its outline, no supports.
PETG, 1.6 mm, so it flexes; thread a cord or a dressing gown belt. Prints flat as a plate, no supports.
PETG; measure your knob, the cup is 56 mm inside. Prints as shown on its floor, no supports.
Print flat in PETG.
Matt black filament gives the best contrast. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.