Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Amplify phone sound without power
Stand your phone speaker-down in the slot and the hollow box carries its sound out through the two side horns and the perforated front; no power needed.
Printing notes
57.2 cm³
Volume
70.9 g
Est. weight
10,316
Triangles
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
MAIN PURPOSE: Sort receipts by tax quarter
Four upright bays for receipts and invoices, labelled Q1 to Q4 on the front, so the tax year sorts itself as you go.
Printing notes
87.9 cm³
Volume
109.0 g
Est. weight
12,032
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold petty cash coins and notes
Four coin cups along the front and a long well for notes behind them, under a telescoping lid with CASH on top.
Printing notes
261.5 cm³
Volume
324.3 g
Est. weight
8,260
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Store bare hard drives standing apart
Four padded-width slots that keep bare 3.5-inch hard drives standing apart, numbered on the front, with a label slot.
Printing notes
106.5 cm³
Volume
132.0 g
Est. weight
4,056
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Align cables in neat parallel lines
Thread up to eight cables through the comb and slide it along the bundle, so a desk-to-floor run lies in neat parallel lines.
Printing notes
18.0 cm³
Volume
22.3 g
Est. weight
1,356
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Store small parts with easy scoop access
A deep parts bin with a low front, a scooped inner front edge that funnels parts to your fingers, and a label slot.
Printing notes
52.2 cm³
Volume
64.8 g
Est. weight
1,234
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Identify drill bit and dowel sizes
A flat gauge with eight holes from 3 to 14 mm and the size engraved under each, for identifying drill bits, dowels and bolts.
Printing notes
50.9 cm³
Volume
63.1 g
Est. weight
11,256
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Store a rafter speed square
A tray with a recess shaped exactly like a 7-inch rafter square, so it always goes back in the same place.
Printing notes
439.7 cm³
Volume
545.2 g
Est. weight
1,224
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a multimeter and its probes
A deep fitted caddy for a multimeter with a long channel beside it for the test probes and leads.
Printing notes
313.4 cm³
Volume
388.7 g
Est. weight
1,772
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store wire strippers in a drawer
A thin shadow board for a tool drawer with a recess shaped like a pair of wire strippers.
Printing notes
101.2 cm³
Volume
125.5 g
Est. weight
748
Triangles
Prints flat as a plate, no supports.