Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the turntable ring separately and drop in 6 mm steel or airsoft balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the sleeve upright and the two drawers flat; line the cells with felt for wooden pieces. Prints as shown on its floor, no supports. The 2 drawers print separately from the case.
Sized for travel checkers up to 34 mm across; scale the tubes for full-size checkers. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added bases' lids print separately.
Print two, one for each player; a wood-fill filament suits the game. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print four, one per seat; the five slots take the bid cards from 1 to 7. Prints as shown on its floor, no supports.
Light colour so the ball shows. Use an 8 mm steel ball. Prints as shown on its outline, no supports.
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print two flat in PETG, 4 mm, in two colours. Prints flat as a plate, no supports.
Print in black; fill with cork or putty. 6 x 2 mm magnet. Prints as shown on its outline, no supports.
Print open side up, glue in a coin, then flip. Print floor-down as shown, then turn it over to use it.