Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Put a sponge soaked in 1:4 sugar water in some petals and orange slices in others; refresh every two days. Prints as shown on its floor, no supports.
PETG or PP; water-based ink rinses straight off. Prints as shown on its floor, no supports.
Put it in the middle of the board-game table, one arm towards each seat. Prints as shown on its floor, no supports.
Lay out the primaries at 12, 4 and 8 o'clock and mix the in-between wells. Prints as shown on its floor, no supports.
Print in a tan or brown; a long sausage dog fits a row of pens nose to tail. Prints as shown on its outline, no supports.
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.
Print in green or a marble filament for the shell. Prints as shown on its outline, no supports.
The quill shaft at the bottom is a handle for lifting it off the desk. Prints as shown on its outline, no supports.
Print in white or translucent filament; 0.4 mm walls show off the fractal edge. Prints as shown on its outline, no supports.
Food-safe PETG; the two sides lift out for the dishwasher rack. Prints as shown on its floor, no supports.