Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Glue a sheet of glass or acrylic in the slab bay for the smoothest roll-out. Prints as shown on its floor, no supports.
Print in coral or purple; each curling arm holds one cable end. Prints as shown on its outline, no supports.
Print in red or green with the word in gold; envelopes stand in three rows. Prints as shown on its floor, no supports.
Fits 12.7 x 28 cm pop-up foils; screw it to the trolley through the keyholes. Prints as shown on its floor, no supports.
Print in turquoise, gold or deep blue. Prints as shown on its outline, no supports.
Print two, one dark and one light, and turn one round so they lock into a circle. Prints as shown on its outline, no supports.
Seen from above, the three bays make the classic tumbling-block cube illusion; paint them three shades. Prints as shown on its floor, no supports.
Brush both walls with release oil, pour fine concrete into the gap, cure 48 hours, then flex the mould off. Prints as shown on its floor, no supports.
Use LED tea lights, or real ones in metal cups only; print in PETG for warm rooms. Prints as shown on its floor, no supports.
Print in a deep green; a 0.2 mm layer keeps the slit ends crisp. Prints as shown on its outline, no supports.