Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in ASA or PETG for outdoors. Prints flat as a plate, no supports.
Print floor-down as shown, then turn it over to use it.
The 22 mm bore is a press fit; sand it lightly if the bearing will not go in. Prints flat as a plate, no supports. Large holes in the walls may need supports or good bridging.
Check the 31 mm hole spacing against your motor before bolting up. Prints flat as a plate, no supports.
Print in PETG with 5 walls; not for load-bearing handrails. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Prints flat as a plate, no supports. Large holes in the walls may need supports or good bridging.
Print in PETG and use 3 mm cord; knot the cords inside each hole. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.