Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Slots take standard 7.5 cm square tiles on edge; the side bin takes triangles. Prints as shown on its floor, no supports.
Print in purple for the classic T piece; it tessellates with other tetromino bins in a drawer. Prints as shown on its floor, no supports.
Holes take 16 mm test tubes; the lower tray catches spills. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the tiers alternately red and white. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the hub white and the pods grey. Prints as shown on its floor, no supports.
Feed a cable up through each back port; a 3-port USB charger fits behind it. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Holes fit 9 mm and 13 mm ink caps; wrap in barrier film as usual. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the big oxygen cup red and the two hydrogen cups white, like a school model. Prints as shown on its floor, no supports.
Tips rest in the chamber below; a damp paper towel in the base keeps them fresh. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print each step in a bright papel-picado colour; LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.